Partial degradation and biological activities of an antitumor polysaccharide from rice bran.

A rice bran polysaccharide designated RON was subjected either to partial hydrolysis with formic acid or to partial degradation by ultrasonic irradiation. A significant change in the molecular size was also observed during simple chromatography of RON on a strongly acidic ion exchange resin, although the apparent molecular weight of RON had been assumed to be more than 1 x 10(6) daltons (Da). This fact indicates that RON exists as molecular aggregates, presumably mediated by metal cations. Degradation products with average molecular weights above ca. 1 x 10(4) Da which were obtained by any of the three methods still retained the following activities of RON: in vivo antitumor activity against Meth-A fibrosarcoma in mice by oral administration, and in vitro macrophage stimulatory effects to induce tumoricidal activity and interleukin 1 production. This molecular size was proven to be the minimum requisite for these activities because smaller fragments were scarcely active. The aggregation was characteristic of RON but not essential for its antitumor activity because definite, though slightly reduced, activity was exhibited even by the smaller fragments obtained after the ion exchange resin treatment.     

An efficient fluorescence sensor for superoxide with an acridinium ion-linked porphyrin triad

Addition of potassium superoxide with 18-crown-6 ether (KO(2)(?-)-18-crown-6) to a toluene solution of an acridinium ion-linked porphyrin triad (Acr(+)-H(2)P-Acr(+)) resulted in a remarkable enhancement of the fluorescence intensity. Thus, Acr(+)-H(2)P-Acr(+) acts as an efficient fluorescence sensor for superoxide. Electron transfer from KO(2)(?-)-18-crown-6 to the Acr(+) moiety to produce the two-electron-reduced species (Acr(?)-H(2)P-Acr(?)) results in inhibition of the fluorescence quenching via photoinduced electron transfer, as revealed by laser flash photolysis measurements.     

Determination of total cholesterol in serum by high-performance liquid chromatography with electrochemical detection

A simple and sensitive HPLC method that does not require derivatization for determining cholesterol has been developed. Investigation of voltammetric behavior of cholesterol showed that cholesterol could be oxidized on a glassy carbon electrode in non-aqueous solvents. This was applied to the development of a method by HPLC with electrochemical detection (HPLC-ED). The HPLC-ED was optimized using the separation of cholesterol and oxysterols including 26-hydroxycholesterol and 24S-hydroxycholesterol. The separation was carried out with a Develosil C30-UG-3 column; acetonitrile-2-propanol (9:1, v/v) containing 50mM LiClO(4) as a mobile phase; and an applied potential at 1.9V versus Ag/AgCl. The current peak height was linearly related to the amount of cholesterol injected from 0.5-100 microM (r>0.999). The detection limit (S/N=3) of cholesterol was 0.36 microM (1.8 pmol). Cholesterol at 100 microM was directly detected with a relative standard deviation (RSD) of less than 1.0% (n=8). Total cholesterol and free cholesterol in control human serum were determined by the present method with the recovery of more than 90% and the RSD (n=6) of less than 3.0%.     

Determination of vanillin and related flavor compounds in cocoa drink by capillary electrophoresis

In the first part of this study, the stability of five terpenes (alpha-pinene, limonene, camphor, citronellol, and carvacrol) under subcritical water conditions was investigated. The stability studies were carried out at four different temperatures (100, 150, 200, and 250 degrees C) with two different heating times (30 and 300 min). When water temperature was increased, the degradation of terpenes became more serious. Prolonged exposure time to each heating temperature also caused decreased terpene stability. The terpene recoveries were determined by conducting subcritical water extraction of sand spiked with terpenes. The recoveries are typically around 70 to 80% for extractions at 100 degrees C. Terpene recoveries were decreased with increasing water temperature due to poorer stability of terpenes. After the degradation and recovery studies, basil and oregano leaves were extracted using water at both 100 and 150 degrees C. The concentrations of each individual terpene in the water extract generally ranged from trace quantity to 65 microg terpene/g herb. However, the concentration of carvacrol in the oregano-water extract at 150 degrees C was found to be as high as 4270 microg carvacrol/g oregano.     

Chemical trend of Ln-M exchange couplings in heterometallic complexes with Ln = Gd, Tb, Dy, Ho, Er and M = Cu, V

The 4f-3d exchange couplings were definitively and precisely determined in the dinuclear complexes (Ln-M) involving double μ-oxo-bridges, by means of combined high-frequency electron paramagnetic resonance and pulsed-field magnetization techniques, revealing a monotonic decrease of ferromagnetic J(Ln-Cu) in the order of the atomic number, (64)Gd to (68)Er.     

Optimization of HPLC-ECD conditions for determination of catechins with precision and efficiency based on the FUMI theory.

A chemometric tool based on the Function of Mutual Information (FUMI) theory can provide a relative standard deviation (RSD) without repetitive measurements in high-performance liquid chromatography with electrochemical detection (HPLC-ECD). Two parameters: precision (= information content) phi and efficiency (= information content/time) theta, which were calculated from predicted RSD based on the FUMI theory, were used to optimize HPLC-ECD conditions, such as applied potential, flow rate, column length, and size of ODS porous packing. We selected catechins as analytes, and found that the most optimum applied potential and flow rate were +600 mV vs. SCE and 0.9 mL/min, respectively, because they gave the largest phi and theta values. Buffer concentration in mobile phase is less effective for giving large phi and theta values. Since the FUMI theory makes it possible to predict RSD without repetitive measurements, the present method saves considerable amounts of chemicals and experimental time, and was found to be useful for the optimization of experimental conditions for determination by HPLC-ECD.     

Radiation-induced polymerization at high dose rate. II. α-Methylstyrene in bulk

Bulk polymerization of α-methylstyrene was carried out in a wide dose rate range, 7.6–256 rad/sec by γ rays and 8.5 × 10³–2.1 × 10⁵ rad/sec by electron beams. At high dose rate by electron beams, cationic polymerization took place along with formation of oligomeric product of DP _n = ～4. At low dose rate by γ rays, radical polymerization was found to occur in water-saturated monomer. The cationic polymerization at high dose rate proceeds with essentially the same mechanism as was already known in γ-ray polymerization of dry monomers. Relatively low reaction rate of the cationic polymerization compared with that of styrene is explained with the fact that the propagation of α-methylstyrene is much more easily inhibited by a slight amount of water.     

Selective photocatalytic oxidation of alcohols to aldehydes in water by TiO2 partially coated with WO3

Semiconductor TiO₂ particles loaded with WO₃ (WO₃/TiO₂), synthesized by impregnation of tungstic acid followed by calcination, were used for photocatalytic oxidation of alcohols in water with molecular oxygen under irradiation at λ>350 nm. The WO₃/TiO₂ catalysts promote selective oxidation of alcohols to aldehydes and show higher catalytic activity than pure TiO₂. In particular, a catalyst loading 7.6 wt % WO₃ led to higher aldehyde selectivity than previously reported photocatalytic systems. The high aldehyde selectivity arises because subsequent photocatalytic decomposition of the formed aldehyde is suppressed on the catalyst. The TiO₂ surface of the catalyst, which is active for oxidation, is partially coated by the WO₃ layer, which leads to a decrease in the amount of formed aldehyde adsorbed on the TiO₂ surface. This suppresses subsequent decomposition of the aldehyde on the TiO₂ surface and results in high aldehyde selectivity. The WO₃/TiO₂ catalyst can selectively oxidize various aromatic alcohols and is reusable without loss of catalytic activity or selectivity.     

Valency states of radioactive antimony in hydrochloric acid solutions. Preparation and stability of antimony tracer for radioanalytical use

Variations of¹²⁵Sb valency states in HCl solutions were investigated by the use of the N-benzoyl-N-phenyl-hydroxylamine (BPHA) extraction method.¹²⁵Sb(V) is completely reduced to Sb(III) by one hour refluxing in conc. HCl.¹²⁵Sb(III) is gradually oxidized to Sb(V) in solutions of low HCl concentrations by the effects of their own radiations. Natural light promotes such oxidation reactions. By utilizing such oxidation-reduction effects¹²⁵Sb(V) can be easily prepared from¹²⁵Sb(III) and also¹²⁵Sb(III) can be prepared by the reduction of Cl _aq ⁻ . Their valency states were stable on keeping them in brown-colored bottles at 6M HCl concentrations.     

The effect of fluorination: a crystallographic and computational study of mesogenic alkyl 4-[2-(perfluorooctyl)ethoxy]benzoates

The series of alkyl 4-[2-(perfluorooctyl)ethoxy]benzoates (F8-n) shows a systematic change of crystal structures depending on the length of the alkyl chain: separate packing of perfluorooctyl (Rf) and alkyl (Rh) chains from each other for shorter (n=2) and longer (n=11) members, alternate packing of Rf and Rh chains for middle (n=6,7) members, and an intermediate type of packing for n=4. Semiempirical MO calculations show slightly repulsive interactions between the Rf chains, and attractive ones between Rf and Rh chains and between Rh and the core of a molecular pair. It is concluded that fluorination determines the molecular shape of the crystal structures by making the chain rigid. It is confirmed that the interactions between Rf chains are small compared with those between other moieties and that they are forced to aggregate owing to the exclusion from other moieties. Thus, the effect is dependent on the geometries and intermolecular interactions of the other moieties.